|
Lighting Sensor
1.Features
Using an advanced optical sensing system, optical/electrical signal conversion, microprocessor signal processing, and a control algorithm, the automated car light sensor can detect the surrounding light condition, automatically activate or deactivate the headlight or low beam headlight and dashboard light. This technology provides drivers with added safety, convenience, and comfort in various weather conditions.
2.Advantages
· Automation
It can detect surrounding
light conditions and automatically activate or deactivate the headlights
· Adjustability
The sensitivity of the light sensor is adjustable.
· added safety, convenience
When you start the car, it automatically put the light sensor into working condition, and detect the light condition.
· Mode change
It has manual and auto mode switch, you have the choice
· More
When you switch off the engine or go somewhere brighter, the light sensor can automatically turn off the headlight, save the battery and prolong battery lifetime.
Rain Full Sensor
1. Introduction：
The Rain Sensor is a highly versatile device for automatic wiping of vehicle windscreen when it is wet due to moistue,raindrops or even mud.It works by reflecting harmonious light beams within a windscreen a drop in the light beam intensity.The system then activates the wipers to operate in fully automatic.
2. Benefits：
1). Safety:
The 0.1 seconds response time allows for quicd reaction when sudden splashes of water totally`blinds`the driver.without the Rain Sensor the driver would be in a risk of an accident.
2).Comfort:
a driver may be subjected to many distractions:heavy traffic,bad weather,dangerous road conditions and fatigue.The Rain Sensor reduces the driver`s burden,making driving more comfortable.Trailing a wet car is no longer a nuisance as detection of even 0.005 milliliters of water is possible.
c. Features:
1). Automatic Wiper Frequency.
2). Intelligent Wiper Speed Contrd.
3). Auto Tuning for Different Windscreen.
Installation:
1. Open the wiper to see the scope of work scraping piece; Note: The sensor head installed in the wiper within the scope of activities
2. To clean the windscreen of the car;
3. According to the shape and structure of the backview mirror cutting patch;
4. Tear the patch, be careful not to dirty the surfaces; Note: The stick side attached to the glass surface
5. First, spray a small amount of water in the glass, and then paste the patch on the front windshield , move to the right Position; Note: To paste correct position, and out of the bubble)
6. And then cut another patch before the tear, be careful not to dirty surfaces; Note: The film side attached to the glass
7. Hands shun the direction of patch by squeezing so that no air bubbles between the windshield and the former. Note: The film stickers, wait 30 Minutes later, the sensor head can be affixed.
Sensor installation
1. Remove protective film on the sensor head first ; Note: The middle of sensor head is sense area.
2. And then remove the protective film of the double-sided sticker around the sensor head
3 .. first sensor head bottom sticking to the patch , and then stick tightly from bottom to top; Note: align the middle of the sensor window and the middle of the white transparent window on the patch
4. Using hands pressed Sensor head againest the glass film, the Note: After the that, check not air bubbles between the sensor head and the glass film.
 
Connect Cables:
 
|
